When an object refuses to go where you want it, Clean Start has three different causes and they need three different answers: a piece of furniture is standing in the way of a cleaning task, a container has swallowed the object, or the placement collision check simply does not register a valid spot. This is the Clean Start objects will not fit or place guide, and it works through the three in the order you are likely to hit them.

Clean Start objects will not fit or place guide: the three causes

  1. Furniture is standing in the way of a cleaning task. If a movable object such as a lamp is in front of a surface you have to clean, that surface will not clear — the game is not refusing the placement, it is telling you the surface is still covered. Right-click to leave cleaning mode, move the lamp, then enter cleaning mode again. There is no tip in the demo that explains this, so it is worth knowing before you go looking for a bug.

  2. A container has swallowed the object. A pair of heels put inside a suitcase makes the suitcase refuse to open, so the heels cannot be taken out again. Throwing the whole suitcase away then leaves the game with an item it does not count as thrown away, and the room cannot be completed — the demo has no reset-room option, so the only way out is starting a new game. This was fixed in a later demo build. The rule that prevents it is simple: do not put loose objects inside suitcases, drawers or other containers while you are sorting a room.

  3. The placement collision does not register. An object that clearly has room does not register, most often books on a shelf in the living-room level, and several items clip into each other when placed close together. The collision behaviour was reworked and the fix shipped in a later demo build, together with the hint system, so an up-to-date demo build should not show it.

Cases 1 and 2 are about the state of the room; case 3 was a fault in the build itself, and the two are worth telling apart before you spend an evening on it. Leaving cleaning mode and moving the lamp is a mouse action covered in the controls guide.

When a picture ends up behind the wall

A picture taken off a wall can end up behind the wall and refuse to go back up. Zooming out with the wheel can also rotate the object you are looking at, which makes a flat object look misaligned when it is not — picking the object up and putting it down again resets the view.

What the demo cannot do

Two limits are worth knowing before you start arranging a room precisely:

  • There is no camera rotation for the room itself. You look at each diorama from the same angle the studio chose, and edge scrolling is the only way to pan.
  • There is no way to rotate a held object by 90 degrees with the right mouse button. Aligning items to a shelf wall means adjusting them by small increments with the mouse. The arrow keys or WASD rotate an object in inspect mode instead, which is the workaround the game gives you.

Where the objects you keep belong once they are placed is covered on the apartment decorating guide.