TANUKI: Pon's Summer controller not working is almost always a Steam Input problem, not a hardware fault. The game supports DualShock 4, DualSense, Xbox pads and 8BitDo pads natively — so when a pad is completely ignored, the fix is to stop Steam Input from translating it into keyboard and mouse commands the game never sees.

If the pad works in Big Picture but goes dead once the game is running, that confirms the diagnosis rather than ruling it out.

The TANUKI: Pon's Summer controller not working fix, step by step

  1. Open the game's Properties in Steam and go to the Controller tab.
  2. Set "Override for TANUKI: Pon's Summer" to "Disable Steam Input" — not "Use default settings" and not "Enable Steam Input". This is the setting that matters; the global Steam Input preference does not override it.
  3. Relaunch the game and test the pad.
  4. Reconnect the pad over Bluetooth if it works in Big Picture but dies in-game. Reconnecting is the fix; changing the layout is not.
  5. On Steam Deck, use the Deck's own Controller Order setting to put the right pad first when an external controller is plugged in.
  6. Clear the virtual Steam Input devices for this game if several controllers are detected at once or phantom inputs appear out of nowhere.

The same conflict shows up on Linux, where a DualSense is announced as supported but Steam Input maps it to keyboard and mouse and the game does not pick it up at all. The affected pads reported so far are the DualSense (PS5), the DualShock 4 (PS4), Xbox One and Series pads, and 8BitDo pads.

Making the bike accelerate

A working pad can still feel broken, because the right trigger on its own does nothing. The trigger is the throttle, but the left stick has to be tilted forward as well — pressing only the right trigger produces no acceleration at all. The acceleration controls guide has the full picture, including the jump timing.

Two control layouts

The game offers two control layouts — a Tanuki layout and a Bird layout — switchable in the options, and the scheme can be changed for the bike and for on-foot movement separately. The Bird layout suits many players better, but it reads the same triggers for the BMX and the on-foot controls, and the players who struggled most were the ones who had to learn a trick before they could change the scheme.

The trick list that those buttons map to is in the BMX trick controls guide, with the full button-by-button table.

When it is not Steam Input

Two smaller causes show up in the reports:

  • The game was installed before the controller was paired. Re-pairing the pad from Steam's controller section refreshes it.
  • The layout was changed after learning the controls. If the pad works but the buttons feel wrong, that is the layout, not the connection — reset the scheme for the bike and for on-foot movement separately in the options rather than uninstalling anything.